The linkage was media blasted and refinished using Eastwood Carb Renew Silver Aerosol, Item 10187 Z.
The brass fitting was brushed, polished and refinished with Eastwood Diamond Clear Satin, Item 10300 Z.
The NOS carburetor was purchased on an eBay auction a few years back for about $40! It pays to look at auctions that list items for Mustangs, Falcons, Fairlanes etc.
This carburetor will be used to get the vehicle up and running. After that the carburetor (and distributor) will be replaced with EFI (Electronic Fuel Injection).
Notice the "HI & LO" settings for the accelerator pump linkage. These settings correspond to the following conditions:- HI - 50 Degrees Fahrenheit and below
- LO - Above 50 Degrees Fahrenheit and/or 5000 Feet Altitude
I replaced the clip that holds the link in place from the spacer to the carburetor with a washer and cotter pin combination.
As always, larger versions of these photos are available here. If you do visit my Flickr site, be sure to hit "Back" on your browser to return to this blog.
Contact Me
No comments:
Post a Comment